LED grille light how to install and install LED grille light steps

The modern furniture decoration is more and more refined, and the glass lamp grille lamp is popular among the public. The so-called LED grille lamp is actually a kind of lighting fixture. It is generally suitable for installation in a ceiling-mounted office. Compared with the previous fluorescent tube, it only replaces the fluorescent tube with LED lamp bead. This is a new type of office energy-saving lamp. Beads are also different in installation from traditional grille lights. So how do you install LED grille lights? Let Xiaobian tell you about it here!

LED grille light

First , remove the LED grille lamp cover

Remove the grille reflector on the lamp panel. Take care when taking the grille reflector. Do not scratch it. Place the lamp body on the reserved ceiling keel . Please pay attention to the position of the four sides when placing it, so that the four sides of the lamp are completely placed on the keel strip to avoid the lamp falling. Note that when the lamp is heavy, please use the wire to hang the lamp on the ceiling. In short, be careful not to damage the lamp. .

LED grille light installation

Second , connect the power cord

Pass the power cable from the outlet hole and connect it correctly to the terminal block. Pay attention to the L- mark at the fire line, the N mark at the zero line, and the ground mark at the ground wire.

Third, the light source is loaded

Insert the light source correctly. When installing the light source, please pay attention to the light source into the lamp slot. After hearing the click, it indicates that the light source is in good contact with the copper plate of the lamp holder. Otherwise, even if the installation is completed, the light may not light up when the switch is turned on. In the case of this, it means that the light source is not in good contact with the copper piece of the lamp cap.

Fourth , stuck the lampshade

Plug one end of the sling of the grille reflector into the sling hole of the lamp body to facilitate subsequent replacement of the light source, and insert the grille reflector into the luminaire body . Note that the shrapnel must be in good contact with the grille reflector to avoid the grille reflector. Fall off.

LED grille light installation steps

Fifth, turn on the light test

Turn on the switch light, the installation is complete, if the light is not bright, you need to carry out step by step analysis and inspection according to the installation procedure of the LED grille light, and then process the cause until it is installed successfully.

The above is the detailed knowledge of how to install the LED grille light , I hope it can help you. After the installation, the website will continue to update all kinds of content about home decoration, so stay tuned.