How to use solar light switches and solar controllers?

April 06, 2023

1. How to use the solar light switch

If it is a light control switch, the solar light will control itself according to the light intensity. When the light is strong during the day, the solar light will automatically turn off, and when the light is dark at night, the solar light will automatically turn on. If it encounters bad weather during the day If it rains, the Solar Lights will also be turned on automatically. If it is a timer switch, it can be self-controlled according to the preset opening and closing time.

2. How to adjust the solar light controller

1. Find the setting button on the controller, press and hold it until the digital tube starts to flash, and then release it. It usually takes 3 seconds. The flashing digital tube means entering the adjustment mode, and you can release the button to adjust.

2. Then press the setting button. At this time, you don`t need to press it for a long time. Press it and release it. You will see that the number on the digital tube will change with the number of times you press the button. Press it once to change a number. It is enough that the mode numbers are consistent.

3. Wait for a while, let the digital tube automatically stop flashing to complete the setting, or you can choose to press and hold for more than 3 seconds to complete the setting.

3. What are the debuggable modes of the solar light controller?

1. Pure light control mode

This mode is the basic mode of solar lights. As long as the light is lower than a certain point, the lighting can be activated. If it is not set properly, the light will not light up, or it will always be on. The pure light control mode is to reduce the light intensity to the start point when there is no sunlight, so that the controller will delay, and the start signal will be confirmed after about 10 minutes.

2. Light control + time control mode

This mode is a more intelligent mode selection for solar lights. It is necessary to set the start conditions of the solar lights, that is, both the light and time conditions. When there is no sun, that is, when the light is extremely weak in the evening, it will pass. The controller is turned on for lighting, and the lighting time will also be set. If it is set for 10 hours, it will be turned on at 7 pm and will be automatically turned off at 5 am.

3. Manual mode

The user can directly turn on and off the solar light on the controller. This mode is generally seldom used, and it is only used in special load occasions, or it will be used in the maintenance and debugging of the solar light.

The above content is provided by WOSEN. WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349

Author:

Ms. Mandy

E-mail:

admin@wosenled.com

Phone/WhatsApp:

+8613425434349