1. There are three installation methods for Led Panel Lights: embedded, ceiling-mounted, and suspended. First, you need to determine what kind of installation. 2. Prepare needle nose pliers, some solder, AB glue, multimeter, etc. 3. It is also necessary to determine the specifications of the led panel light to see if it meets the required brightness and quality, whether it is damaged, and everything can be installed without any problems. 4. Fix the light board according to the selected installation method, and then use an electric soldering iron for soldering, and control the temperature of the soldering iron to maintain above 200 degrees Celsius. The soldering can be completed in about one second, and the circuit board cannot be damaged for too long. damage. 5. The polarity of the led should be divided well, there are positive and negative poles, the long is positive, and the short is negative. 6. The connection on the lamp can be passed through the drill hole and the connection behind the lamp can be fixed with a wire clip, to ensure that it is firmly fixed.
7. Ensure that the power cord of the lamp has sufficient length, avoid tension during installation, and do not make the connection knotted. The output connection should be distinguished and not confused with others. 8. The rest can be installed in accordance with the installation instructions, and the installation instructions are also carefully read, and the actual installation will be carried out after you are familiar with it.
LED panel light installation attention
1. The installation of the product must be a licensed professional electrician. 2. Check the integrity of the product when taking it out of the box. 3. The distance between the product and flammable materials should be at least 0.2m, and the installed zenith should have 2 If there is a gap of centimeter height, all lamps cannot be installed inside the ceiling or beside the wall with heat source. Pay attention to separate low-voltage and high-voltage electrical wiring. 4. The connection on the lamp can be passed through the drill hole and the connection behind the lamp can be fixed with a wire clip, to ensure that it is firmly fixed. 5. Make sure that the power cord of the lamp has sufficient length and is not subjected to tension or tangential force. Avoid excessive pulling force when installing the connection of the lamp, and do not make the connection knot. The output connection should be distinguished, and should not be confused with other lamps. 6. After installation, connect the low-voltage plug of the lamp to the low-voltage plug of the switching power supply.
The above content is provided by WOSEN. WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349
