Some Knowledge of IP65 Solar Street Lights

Waterproof Solar Street Light rely on solar power for lighting, but the actual effective sunshine and light intensity in different regions are often different, so manufacturers will customize and produce solar street lights with different performance specifications according to the actual situation in different regions. Therefore, when installing or renovating in different regions, we must pay special attention to choosing the most suitable solar street lights based on the actual situation in our own region, and strive to meet the daily use without wasting resources.

First of all, we need to briefly understand the working principle of Waterproof Solar Street Light Solar. It uses the principle of photovoltaic effect of solar cells. During the day, solar cells absorb solar photon energy to generate electrical energy, which is stored in the battery through the controller. When night falls or the brightness around the lamp is low to a certain When the value is high, the controller will perform the discharge operation by itself and turn on the street lamp to start lighting.

Therefore, when purchasing solar street lights in different regions, we must pay special attention to whether the design ideas and key points of the system are in line with the actual local conditions. We should not blindly pursue low prices just to save investment, nor blindly pursue high performance to cause waste of resources.

1. The installation time of IP65 Solar Street Light. It should be installed on a sunny day. If it is installed on a rainy day, it will only consume power without charging after the light is turned on, which will not meet the drawing requirements;

2. The solar street light should not be turned on on the day after it is installed. In order to be eager to see the lighting effect, many construction companies will turn on the lights at night after installation. Because the new lithium battery is not fully charged when it leaves the factory, if the light is turned on after installation, it will not reach the number of rainy days described. The correct way is to connect the controller after the installation, but not the load, and then connect the load at dusk the next day after charging for a day during the day, so that the battery capacity can reach a higher level. Of course, doing so will add some labor costs.

Ip65 Led Solar Street Light 18

3. The angle of the solar panel is usually drawn by the manufacturer according to the inclination angle of 45 degrees, so as to ensure a better charging capacity in winter. However, the direction angle is determined during installation. When assembling the solar panels underground, it is found that the angle of view is wrong after the light pole is erected. If the error is almost the same, it is usually not adjusted. Such an angle error not only affects the charging experience, but also affects the voltage of the solar panel under the same illuminance, which will lead to a relatively large error in the turn-on time of the solar street light. Therefore, when assembling on the ground, try to adjust the azimuth of the solar panel to keep it consistent!

Fourth, the connection of solar street lamp controller. A waterproof controller should be used as much as possible to ensure long-term stability and prevent users from changing the lighting time at will. If you use a non-waterproof controller, because the terminal is facing down, the wiring is bent into a U shape, which can prevent water from pouring into the controller from the wire.

The above content is provided by WOSEN. WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349