Troubleshooting Methods For Solar Street Lights

October 31, 2022

The maintenance method of Solar Street Light failure, let the editor of solar street light manufacturer WOSEN tell you.

1. The whole light is off

Solar street lights belong to outdoor lighting, and often encounter high temperature or rainy conditions, low temperature or rainy and snowy weather, etc. The controller of solar street lights is usually installed inside the lamp pole, and it is easy to cause a short circuit of the controller after the rain enters. Phenomenon. First check whether there are water marks or rust on the wiring part of the controller. If so, it is very likely that the controller has been damaged and the battery voltage measurement is not carried out. Does not store electricity and needs to be replaced. Then check whether the battery board has voltage and current output under normal working conditions. If not, the battery board is damaged, replace the battery board. There is no problem with the above, you should check the light source, only connect the power supply to the light source to see if it is lit, if not, replace the light source.

2. The lamp head flashes

The reasons for this failure are poor line contact, battery power loss, and serious decline in stored power. If the line is no problem, replace the battery.

3. Short lighting time

Rainy days last for a short time. Usually, the storage capacity of the battery decreases, and the storage capacity is insufficient, and the battery can be replaced with a reasonable one.

Environmentally Friendly Solar Street Lights

4. The solar street light source is not fully bright

Many solar street lights use dot-matrix LED light sources. In addition to the quality problem of the LED light source itself, some lamp beads are soldered, which will cause this situation. The solution is to replace the corresponding lamp beads, weld firmly or replace the entire street lamp head.

5. The problem of battery

If the lighting time is short, the energy storage of the battery decreases, resulting in rainy weather and the lighting time is short, that is the problem of the battery, and the battery should be replaced.

6. The problem of LED light source

In addition to the quality problem of the LED light source itself, the lamp beads of the solar street light are not fully lit. In addition to the quality problem of the LED light source, it is also a welding problem. The failed lamp beads should be replaced in time or the lamp beads should be welded firmly or the lamp head should be replaced more directly.

The above content is provided by WOSEN. WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349

Author:

Ms. Mandy

E-mail:

admin@wosenled.com

Phone/WhatsApp:

+8613425434349